10″ x 5-1/2″ x 5/8″ – Simonds International

Currently viewing:10″ x 5-1/2″ x 5/8″

Item #: 19100250

This knife is used on the following machine models:

Bandit: 1290H, 1590, 1890 and 2090 (uses 5/8″ hardware)
- Note: this knife is used on machines manufactured after November 1999
Rayco: RC12, RC 16.5, RC20 and RC20XP

Our brush chipper knives are manufactured to OEM standards using the same modified A8 chipper knife steel we use in making our sawmill and pulp mill chipper knives. We’ve found that using this material has the best balance of abrasion resistance, cutting edge retention and impact resistance of any material we’ve identified. The Big Rapids facility has a first rate heat treat process that can allow us to control the hardness of the cutting edge while maintaining the softer, more ductile, center very accurately. Proudly manufactured in the USA!

Length: 10″
Width: 5-1/2″
Thickness: 5/8″
# of Holes: 5
Bevel Angle: 30 Degrees
Weight: 7.35 lbs

PROUDLY MADE IN THE USA!

Simonds brand machine knives are made at our plant in Big Rapids, Michigan, USA. Our knives are made from the finest quality knife steel available, in which we use a rigorous process to qualify steel vendors. Simonds of Big Rapids takes pride in the fact that all of our heat treatment processes are in house, giving us the ultimate in control. We apply the same rigorous standards and methods across our wide range of knives, from brush chipper knives to veneer lathe knives and everything in between.